Knowledge Management System of Hefei Institute of Physical Science,CAS
LD端面抽运Nd:GYSGG最佳增益长度分析与实验研究 | |
其他题名 | Analysis and experiment of the optimal gain length in LD end-pumped Nd: GYSGG lasers |
2014-01-01 | |
发表期刊 | 激光技术 |
ISSN | 1001-3806 |
摘要 | 激光二极管(LD)端面抽运激光器存在一个最佳增益介质长度,过长或者过短的晶体都会导致激光器输出性能的降低。为了研究热致衍射损耗对最佳增益介质长度的影响,采用理论分析与实验相结合的方法,通过对晶体增益与损耗平衡理论分析计算,求解得到了Nd:GYSGG晶体的最佳增益长度为7.8mm。同时开展了对不同长度晶体的激光对比实验,证明了接近最佳增益长度的8mm晶体实验效果最佳,在脉冲抽运频率1kHz、能量约7.6mJ条件下,获得了约2.4mJ激光输出,相应的光光转化效率为31.6%。结果表明,该研究对LD端面抽运Nd:GYSGG激光器的优化设计具有参考意义。 |
其他摘要 | There is an optimal length of gain medium in a laser diode (LD) end-pumped laser. The laser output performance will be worsened for too long or too short crystal. In order to study the influence of thermally induced losses on the optimal gain medium length, the method of combining theoretical analysis and experiments was adopted. Through theoretical analysis of the balance between gain and losses in the laser medium, the optimal gain length of Nd:GYSGG was calculated to be 7.8mm. With experiments of laser crystals of different lengths, the best laser output performance was conformed at 8mm. The maximum output energy is about 2.4mJ with pump energy ofT. 6mJ at the repetition rate of lkHz, corresponding to the optical efficiency of 31.6%. The results show that the investigation is significant for design and optimization of end-pumped Nd:GYSGG lasers. |
关键词 | 激光器 最佳增益介质长度 热致衍射损耗 Nd GYSGG 端面抽运 |
收录类别 | CSCD |
语种 | 中文 |
CSCD记录号 | CSCD:5053703 |
引用统计 | |
文献类型 | 期刊论文 |
条目标识符 | http://ir.hfcas.ac.cn:8080/handle/334002/64205 |
专题 | 中国科学院合肥物质科学研究院 |
推荐引用方式 GB/T 7714 | . LD端面抽运Nd:GYSGG最佳增益长度分析与实验研究[J]. 激光技术,2014,038. |
APA | (2014).LD端面抽运Nd:GYSGG最佳增益长度分析与实验研究.激光技术,038. |
MLA | "LD端面抽运Nd:GYSGG最佳增益长度分析与实验研究".激光技术 038(2014). |
条目包含的文件 | 条目无相关文件。 |
个性服务 |
推荐该条目 |
保存到收藏夹 |
查看访问统计 |
导出为Endnote文件 |
谷歌学术 |
谷歌学术中相似的文章 |
百度学术 |
百度学术中相似的文章 |
必应学术 |
必应学术中相似的文章 |
相关权益政策 |
暂无数据 |
收藏/分享 |
除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。
修改评论